Upgrades may be obtained by calling ICS at 217-651-4441


BASIC REPEATER CONTROLLER

11/25/02   V1.08   Added the IDer Beacon mode and a enable and disable for DTMF muting
01/05/04   V1.11   Old version
02/25/06   V1.12   Added a disable for the CNTL RX COS mute of the repeater audio
02/25/06   V1.13   The Basic controller will now accept DTMF without the COS
12/16/06   V1.14   The controller is now capiable of almost zero hang time
12/28/06   V1.14T  Pin 27 has a 10 minuite TX fan timer output on it (5v 10ma)
01/24/08   V1.15   The controller now has ID Cancel



LINKER II and LINKER IIa REPEATER CONTROLLERS

01/05/05   V1.16   Added the Force CTCSS encode function

01/30/05   V1.17  
1. Tone freq range increased,
2. Software now works in older Linker II,
3. 5 tones now programmable from a list of tones,
4. new beep occurs when rb memories are changing,
5. new beep avaiable on port 1 when port 2 is active
6. provision to play tones manually
7. New function avaiable to report the current remote base memory number
8. Timeout timer now is reset when the RX goes off, before it reset only when the TX when off

03/08/05   V1.19  
1. Remote base memory number is now given after every remote base memory selection
2. A function was added to enable/disable the above feature

06/07/05   V1.23  
1. The IDer in xpeat will now ID TX 1

06/07/05   V1.25  
1. The software now supports a programmable terminator digit

8/30/05   V1.30  
1. The Linker IIa courtesy tone speed is now programmable
2. Other software operations were improved

9/29/05   V1.30.2  
1. Added ID cancel
2. Added TX 2 ID enable

3/10/6   V1.30.3  
Fixed problem with TX 2 not disabling in xpeat and RX2 has antikerchunker

11/12/6   V1.32  
An option has been added to send RX1 beep when RX1 becomes nonactive and RX2 is active

11/7/7   V1.33  
1. Added a feature to only allow the ID when Port 2 is disabled
2. Added a feature that will allow the user to disable/enable rx2, tx1 and tx2 with one command
3. Added a feature that allows DTMF when RX2 is disabled
4. Fixed the function that allows you to hear RX1 tone when RX2 is active
5. Added a feature that will allow you to hear the responses to dtmf commands in xpeat on TX 1
6. The Reset jumper now works

12/22/7   V1.34  
1. Fixed - stat 5 and squ tail tx2 tmr would run over each other
2. Added - Pulse off TX2 and adjustable timer.
3. Fixed - TX2 locks up when disabled and turned on.
4. Fixed - TX2 does not turn off when DTMF tones are reconized.
5. Added - RX1 can now be enabled/disabled using functions

1/20/8   V1.35  
1. Added the capability to change the ID delay timer

2/9/8   V1.36  
1. Added the RX1 and RX2 hang times
2. Added a feature to allow the tx to be off during the ID delay time

3/17/8   V1.37  
1. The courtesy tones now stay the same after a reset
2. Added a feature to allow the tx2 to be off during the ID delay time