ICS-CTRL

PI-REPEATER-2X CONTROLLER KIT #1

  • 2x independent Repeater Channels
  • Built in Audio Codec
  • Software independent (I2C/SPI/GPIO/I2S interfaces use, We suggest OpenRepeater/SVXlink, but compatible with any application that can control these interfaces)
  • Independent Polarity Select for COS/CTCSS
  • 8x independent GPIO Channels
  • 8x independent 5V, 12-bit Analog-Digital Converter
  • Mulitple Expansion headers for bus access
  • Expansion compatible through Stacking PI Header
  • 8 LEDs to indicate controller status
  • Optional GPS for time/position synchronization
Image of PI-REPEATER-2X Kit #1

PI-REPEATER-2X CONTROLLER

  • 2x independent Repeater Channels
  • Built in Audio Codec
  • Software independent (I2C/SPI/GPIO/I2S interfaces use, We suggest OpenRepeater/SVXlink, but compatible with any application that can control these interfaces)
  • Independent Polarity Select for COS/CTCSS
  • 8x independent GPIO Channels
  • 8x independent 5V, 12-bit Analog-Digital Converter
  • Mulitple Expansion headers for bus access
  • Expansion compatible through Stacking PI Header
  • 8 LEDs to indicate controller status
  • Optional GPS for time/position synchronization
Image of PI-REPEATER-2X Kit #1

LINKER IIa REPEATER CONTROLLER

  • Values entered in Volts, Seconds, WPM (Even Fractional)
  • Remote base / link with memory / frequency control
  • Repeater and Link RX have COS and CTCSS inputs (can be ANDed)
  • 3 multi-featured Auxiliary outputs
  • Over 130 Functions available
  • 9 LEDs to indicate controller status
  • TS 64 control encode/decode with CTCSS enc hang time
Image of Linker IIa Repeater Controller

BASIC REPEATER CONTROLLER

  • Values entered in Volts, Seconds, WPM (Even Fractional)
  • COS & CTCSS inputs for repeater RX (can be ANDed)
  • Control Receiver COS and seperate audio input
  • Over 40 Functions available (V1.15)
  • Separate control receiver inputs - Has Priority
  • 5 LEDs to indicate controller status
Image of Basic Repeater Controller

Single M

  • Fits in a Micor mobile
  • Has onboard pot for Micor squelch
  • Has output for 8 ohm speaker and volume control (LM386 driver)
  • Values entered in Volts, Seconds, WPM (Even Fractional values)
  • Repeater receiver has COS and CTCSS inputs (can be ANDed)
  • Control Receiver COS and audio inputs - Has Priority
  • Auxiliary output - Pulsed / Latching / TX fan control
  • 6 LEDs to indicate status
  • TS 64 support encode/decode with CTCSS encode hang time
Image of Single M

LINKER - DISCONTINUED

Image of Linker