DESIGNED TO BE EASY TO USE
  1. Multiple courtesy tones are used for function programming and remote base activation.
    1. The default tone is short beep for the repeaters main receiver (RX 1).
    2. When in Setup mode the controller will send a “S” for the repeaters main receiver (RX 1)
    3. When the remote base / link is active and its COS drops (RX 2) the repeater will send a “R”.
    4. If a command is entered and then incorrect data is entered the response will be “B” for BAD.
    5. If after a command is entered and more data is required, an “M” will be sent,  ready for MORE data.
    6. If after a command is entered and everything was accepted with no errors a “K” will be sent for OK.

  2. COS voltages and polarities are easily selectable.

  3. When setting voltages they are set in with actual voltage values, 1.23V = 1*23 on the DTMF pad.

  4. Time values are set in in seconds. 23.2 seconds= 23*2 on your DTMF pad.

  5. Other features are set with actual values such as WPM (5 to 20) or frequency CWID (700Hz to 1200Hz).

  6. LEDS are provided for the inputs and ouputs to show "active state" for setup and operation.

  7. DTMF sequences can be in any order. You can even have them as follows
    8. Memory 1   1 2 3
    Memory 2 1 2 3 4
    Memory 3 1 2 3 4 5
    Memory 4 1 2
    The sequence is evaluated when the COS becomes false.

  8. Any DTMF sequence can be used for any one of the available functions.

  9. Functions are only available if they are enabled and then only on the level they enabled 

  10. All functions are avaiable in setup mode simply by entering their 2 digit function code.